Multiboard Longboard Refill 2 Sets and Mold:

• 7-layers of Canadian maple per board
• each set includes 5 pre-engraved template sheets (8 possible shapes), and 2 cross grain sheets
• 3-dimensionally shaped foam mold
• illustrated instructions

Recommended glue amount for this kit: 38 oz

Multiboard Longboard Refill 5 Sets:

• 7-layers of Canadian maple per board
• each set includes 5 pre-engraved template sheets (8 possible shapes), and 2 cross grain sheets

Recommended glue amount for this kit: 93 oz

Use this Refill Kit with the Builder Kit or TAP bag you already have, as an additional supply of veneer.

Note: A 20x70" (or larger) Thin Air Press bag is required for building a Multiboard.

Click here for more skateboard building info

Q: As this kit doesn’t include glue, where do I get it?
A: Glue is available from this website, or locally if you can source Titebond III.

Q: What else do I need to make a board?
A: If you don’t already have these parts in your complete kit, a glue roller, a rasp, and sandpaper. Then a final coat of water-based, water-proof, exterior clear Varathane is recommended.

Q: Can I change the template shapes?
A: You can easily use the template shapes as a base and make changes to customize it to your liking. The pre-engraved template lines can be sanded away or easily covered with graphics or grip tape.

Q: What do I do if my veneer breaks or splits?
A: Veneer is fragile until laminated, and it is common to split or snap (especially the cross grains). A stripe of glue and some masking tape to hold it until it dries will fix broken or split sheets. See video (link)

Q: What else do I need to complete this project?
A: If you choose to set your boards up for riding, select grip tape at our checkout. Or shop locally for your grip, hardware (wheels, trucks and bearings). Use the guide holes on the bottom side to drill the truck holes through, using a 3/16” drill bit. And of course, don’t forget to wear your helmet!