Hurtle Replay Refill 2 Sets With Mold
Designed to supplement our deck builder kits, this special Veneer Refill kit will keep you building more and more boards.
With this second Collab Series kit, a joint effort with UK builder Chris White you can build a board that takes you back-to-the-origins of skateboarding itself. Simple is sometimes best!
Final size deck dimensions are:
Length = 28” (711.2mm)
Width = 7” (177.8mm)
This kit can be pressed in the 14 x 47” Thin Air Press bag or larger.
Hurtle Replay Refill 2 Sets and Mold:
- 7-layers of Canadian maple per board
- Includes 1 laser-engraved graphics face, 1 plain top face, 3 long grain core and 2 cross grain sheets per board
- 3-dimensionally shaped foam mold
- illustrated instructions
Use this Refill Kit with the Builder Kit or TAP bag you already have, as an additional supply of veneer.
The Veneer and Mold Kits are so you can build a different shape of board with the Builder Kit or TAP Kit you already have.
The foam mold, Thin Air Press Bag and pump, edging tool and breather netting are designed to be used for many, many builds.
Keep all your reusable kit parts in good working order by following the maintenance tips included with the kit.
Store unused veneer in a stable environment, away from any heat sources. Protect it from extreme humidity, or lack of it, by wrapping in plastic. Lay veneer flat to prevent warping.
Q: Who is Chris White / Hurtle Skateboards?
A: Check him out here!
Q: As this kit doesn’t include glue, where do I get it?
A: Glue is available from this website, or locally if you can source Titebond III.
Q: What else do I need to make a board?
A: If you don’t already have these parts in your complete kit, a glue roller, a rasp, and sandpaper. Then a final clear coatwater-based, water-proof or out door/exterior Varathane is recommended)
Q: What do I do if my veneer breaks or splits?
A: Veneer is fragile until laminated, and it is common to split or snap (especially the cross grains). A stripe of glue and some masking tape to hold it until it dries will fix broken or split sheets. See video (link)
Q: What else do I need to complete this project?
A: If you choose to set your boards up for riding, select grip tape at our checkout. Or shop locally for your grip, hardware (wheels, trucks and bearings). Use the guide holes on the bottom side to drill the truck holes through, using a 3/16” drill bit. And of course, don’t forget to wear your helmet!
Q: Can I add a color sheet to my order?
A: Yes you can, however as those sheets come as uncut rectangles, you will need to trim that to shape before pressing. For the Pintail kits, we will supply a 42” uncut sheet, as the 48” is too long for the carton.